Phone: (317) 897-7000
Fax: (317) 898-2917

Unit of Measure

Model

N/A D-1050

Cold Rolled Steel

N/A 10 (0.135) gauge

Slide Length - A

N/A 24.00 in

Forward Extension - B

N/A 24.00 in

Weight Capacity

N/A 950 lbs

Weight Capacity Notes

N/A Load capacity is based on one slide at full extension with the load (center of gravity) at the midpoint of the slide (chassis section). For increased load capacity, multiply the number of slides required for the application.
Stated load capacity has a 100% static (non-moving) load safety factor at full extension. Slide is not intended to be operated with continuous loading which exceeds stated capacities.

Options

N/A Mounting Plate

Spec Sheets

N/A D-1050-1054.pdf

Installation Sheet

N/A Installation Sheet

GDI Reference #

N/A CD5600-00-0240

N/A

  • Catalog number D-1054 designates the same slide as D-1050, however, the D-1054 slide locks at the fully closed position (LI) and at the fully extended position (LO).
  • Stationary section is designed for mounting from the bottom (threaded holes). If application requires mounting stationary section from the top side, order optional mounting plates.
  • Slide operates on solid rollers for vertical alignment and ball bearings for horizontal thrust.
  • Measured in the closed (retracted) position.
  • Load capacity is based on one slide at full extension, with load (center of gravity) at midpoint of the slide (chassis section). For increased load capacity, multiply number of slides required for the application.
  • Stated load capacity has a 100% static load (non-moving) safety factor at full extension. Slide is not intended to be operated with continuous loading which exceeds stated capacities.
  • Slide is non-disconnectable.
  • Slide is designed for compression loading only.
  • To prevent internal damage to the slide, maximum mounting screw penetration cannot exceed 0.42 into the stationary section or 0.31 into chassis section.
  • No mounting hardware supplied.
  • Slide members are coated with Poxylube® - a gray-colored dry film lubricant.
  • Slide members are made from 10 gage (0.135) cold rolled steel, and 3/16 C.D. Flat Bar.
  • Non-standard stainless steel slide, coated with Poxylube®, is available. This option will require a special reference number.